Heater Temperature Control Link Unit

Removal

1. Disconnect the battery ground cable.
2. Drain engine coolant.
3. Discharge and recover refrigerant (with air conditioning).
- Refer to Refrigerant Recovery in this section.

4. Remove heater unit.
- Refer to Heater Unit in this section.

5. Remove the case (Temperature control) from the heater unit.
6. Remove rod.
7. Remove sub-lever.
8. Pull out the door lever while raising up the catch of the door lever.
9. Remove clip.

Installation

To install, follow the removal steps in the reverse order, noting the following points:
1. Apply grease to the sub-lever and to the abrasive surface of the heater unit.
2. After installing the link unit, check to see if the link unit operates correctly.