Converter Housing and Oil Pump Assembly

Converter Housing and Oil Pump Assembly





Disassembled View

Disassembly
1. Remove oil pump assembly from converter housing.
2. Remove outer seal ring.
3. Remove gasket.
4. Remove wear plate.
5. Remove oil seal ring.

Inspection and Repair
Visual Check:
If any damage, deformation, or local wear is found in a converter housing, outer seal ring, wear plate, or oil seal ring, replace it.

Reassembly
1. Install wear plate onto oil pump assembly.





2. Install converter housing onto complete oil pump assembly. Align with two short J-38588 guide pins on outer bolt holes.
- Loosely install five 1 3mm bolts.
- Center converter housing using J-38557 centering tool.
- Tighten five inner 1 3mm bolts in an alternating pattern.
Torque: 20 Nm (15 ft. lbs.)
3. Install oil seal ring (3 screws).
Torque: 3 Nm (26 inch lbs.)
4. Install gasket.
5. Install outer seal ring.