Headlining (LWB)

Headlining (LWB)

Parts Location:

Removal

1. Disconnect the battery ground cable.
2. Remove the interior trim panels.
3. Remove the dome light.
- Remove the dome light lens and the fixing screws.
- Disconnect the dome light connectors.

4. Remove the sunroof switch (With sunroof).
- Pry the clip positions free from the sunroof switch bracket and disconnect the connector.







5. Remove the sunvisors.
- Remove the fixing screws and pull out the sunvisor holder (1) to remove it.
- Disconnect the vanity mirror illumination connector (if so equipped).







6. Remove the sunroof finisher (With sunroof).
7. Remove the headlining.
- Remove the headlining fixing clips.

Installation

To install, follow the removal steps in the reverse order, noting the following points.

1. Install the headlining so that the fixing clips will not come off.
2. To install the sunroof finisher (1), first fit it in at one place with the headlining (3) close to the sunroof frame (2), then install the entire finisher tightly by hitting it with a plastic hammer, not allowing it to move up.