Oil Filter: Service and Repair

Oil Filter
Removal
1. Disconnect battery ground cable.
2. Drain engine oil.
3. Remove oil filter using J-36390 filter wrench.

Installation
1. Apply a light coat of engine oil to the oil filter gasket.
2. Hand tighten the filter until the gasket contacts the sealing face.








3. Using J-36390 filter wrench, tighten the filter an additional 7/8 turn or by torque 22 Nm (16.2 ft. lbs.).
4. Fill The oil to the proper lever by following The oil level check procedures.
5. Reconnect battery ground cable.
6. Run the engine and inspect for leaks.