Shifter A/T: Service and Repair
Selector LeverRemoval
1. Disconnect battery ground cable.
2. Set ignition Key in "LOCK" position and selector lever in "P" position.
3. Remove knee pads (1), cluster upper cover (2) and center cluster assembly (3).
4. Remove rear console.
5. Remove front console.
6. Remove selector lever knob and cover assembly.
7. Disconnect select cable.
8. Disconnect shift lock cable.
9. Disconnect harness connector.
10. Remove selector lever subassembly.
Installation
1. Install selector lever subassembly.
2. Connect harness connector.
3. Connect shift lock cable.
4. Connect select cable.
5. Install selector lever knob and cover assembly.
6. Install front console.
7. Install rear console.
8. Install center cluster assembly, cluster upper cover and knee pads.
9. Connect negative (-) battery cable.
10. After installation, make sure that the selector lever operates normally, and that each selector position is properly indicated. (The red mark shows through the window.)