Oil Pump Assembly Installation
Oil Pump Assembly InstallationTools Required
^ J25025-1 Alignment Pins
^ J39855 Stator Shaft Seal Installer
1. Install the J25025-1.
2. Remove the J39855-2 which is part of kit J35855.
3. Install the pump to drum thrust washer (601).
4. Use J36850 or equivalent to retain the washer to the pump.
5. Install the oil pump to case seal (5) on the oil pump assembly (4).
6. Install the pump cover to case gasket (6).
7. Install the oil pump assembly (4) into the case and align all holes properly.
Notice: Refer to Fastener Novice in Service Precautions.
Important: The pump to case bolt O-ring seals (3) must be replaced.
8. Install the pump to case bolts (2) with new O-ring seals (3).
Tighten the bolts to 29 Nm (21 ft. lbs.).
9. Remove the J25025-1.
10. Install the remaining pump to case bolts (2) and O-ring seals (3), in the holes where the J25025-1 were.
Tighten the bolts to 29 Nm (21 ft. lbs.).