Speed Sensor and Case Extension Installation

Speed Sensor and Case Extension Installation (2WD Applications Only)

Tools Required
^ J21426 Rear Seal Installer





1. Using the J21426, install an output shaft sleeve (690) and an output shaft seal (691).
Do not push the sleeve past the machined surface on the output shaft.





2. Install the case extension to case seal (30) and the case extension (31).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the case extension to case bolts (32).
Tighten the bolts to 45 Nm (33 ft. lbs.).





4. Inspect the internal transmission speed sensor for the following conditions:
^ Cracks
^ Nicks
^ Damage





5. Install a new O-ring seal (37) on the internal transmission speed sensor (36).
6. Install the internal transmission speed sensor (36).

Notice: Refer to Fastener Notice in Service Precautions.

7. Install the speed sensor retaining bolt (35).
Tighten the bolt to 12 Nm (9 ft. lbs.).





8. Using the J21426, install the case extension oil seal assembly (34) (model dependent).