Transmission End Play Check
Transmission End Play CheckTools Required
^ J25022-A End Play Fixture Adapter (245 mm and 258 mm)
^ J34725 End Play Fixture Adapter (298 mm)
^ J43205 End Play Fixture Adapter (300 mm)
^ J24773-A Oil Pump Remover and End Play Checking Fixture
^ J8001 Dial Indicator Set
^ J25025-7A Dial Indicator Mounting Post
1. Install an end play fixture adapter.
^ Use J25022-A for a 245 mm and 258 mm turbine shaft (1).
^ Use J34725 for a 298 mm turbine shaft (2).
^ Use J43205 for a 300 mm turbine shaft (3).
2. Install the J24773-A
3. Remove an oil pump bolt.
4. Install J25025-7A (or a 278 mm or 11 in bolt) and lock nut.
5. Install J8001.
6. Set the J8001 to zero.
7. Pull up on J24773-A.
Proper end play should be 0.13 - 0.92 mm (0.005 - 0.036 inch).
8. The selective washer (616), which controls the end play, is located between the input housing (621) and the thrust bearing (615) on the oil pump hub.
If the end play measurement is incorrect, refer to the End Play Specifications table. Choose a new selective washer (616) based on the original selective washer and the information contained in the table.
If the dial indicator shows no end play, the selective washer (616) and thrust bearing (615) may have been misassembled.
9. Correct the end play by changing the selective washer(616).