Electronic Brake Control Module: Testing and Inspection

ELECTRONIC BRAKE CONTROL MODULE PROGRAMMING AND SETUP

EBCM REPLACEMENT
If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:
- EBCM Reprogramming-Refer to Service Programming System (SPS).
- Revise the tire calibration using the Scan Tool Tire Size calibration function.

EBCM REPROGRAMMING
If the EBCM needs to be reprogrammed, refer to Service Programming System (SPS).

YAW RATE SENSOR/LATERAL ACCELEROMETER REPLACEMENT
Replace the EBCM after replacing the yaw rate sensor/lateral accelerometer, and reprogram EBCM.
- EBCM Reprogramming-Refer to Service Programming System (SPS).
- Revise the tire calibration using the Scan Tool Tire Size calibration function.