Electronic Devices - Manual Module Configuration

S418-02

S-TYPE

DATE 11/03

MODEL
2003 MY
S-TYPE

VIN
M44998-M65544

Installation Of New FEM, REM, and DDM - Incorrect VID Block - Use Manual Configuration Option

ISSUE:

On S-TYPE vehicles within the above VIN range, when installing a new Front Electronics Module (FEM), Rear Electronic Module (REM) or Driver's Door Module (DDM), it will be necessary to manually reconfigure the control module(s). Manual configuration is necessary due to incorrect information contained in the Vehicle Identification (VID) Block.

Action:

On S-TYPE vehicles within the above VIN range, manually reconfigure the replacement module(s) as outlined below:

WORKSHOP PROCEDURE

1. Position the WDS alongside the vehicle, switch the Portable Test Unit (PTU) 'ON' and allow the software to load.

Note:
Ensure WDS is loaded with software release JTP 759/26 or later.

2. Connect PTU to the vehicle using diagnostic cable.

3. Enter the VIN and navigate to the configuration main menu.

4. Select 'Configure new modules'.

5. Select and run the application for the appropriate module.

6. Navigate to 'Select option' select and run 'Manual'.

7. Follow the on-screen prompts to 'Vehicle Configuration Modification' screen.

8. Set 'Current Value' relative to vehicle specification, press tick to continue and follow on-screen prompts.

9. After manual configuration of appropriate module is complete, switch 'OFF' PTU, disconnect from the vehicle and return WDS to original location.

Warranty Information

Note:
The time allowed for manual configuration of the module(s) is included in the SRO to renew the relevant module.