Front Lower Arm

Front Lower Arm

Removal

CAUTION: Nuts and bolts must be tightened with the weight of the vehicle on the suspension.

1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle.
2. Remove the LH front wheel and tire.

3. NOTE: Note the fitted position.

Release the forward lower control arm.
> Remove the 2 bolts and discard the nuts.





Installation
1. Install the forward lower control arm.

> Install the bolt and tighten the new nut to 60 Nm (44 lb.ft) + 135 degrees.
> Tighten the 14 mm bolt to 175 Nm (129 lb.ft).

2. Install the wheel and tire.
3. Using only four-wheel alignment equipment approved by Jaguar, check the wheel alignment, and adjust if required.