VIN Range: G00442->G45170

PINPOINT TEST G295394p2: DTC C1094, C1769, C1782, C1783; PARK BRAKE APPLY SWITCH CIRCUIT FAILURE/SHORT TO GROUND, PARK BRAKE RELEASE SWITCH CIRCUIT FAILURE/SHORT TO GROUND

G295394t3: CHECK THE SIGNAL GROUND TO THE EPB SWITCHPACK
1. Measure the resistance between TL82, pin 02 (BK) and GROUND.

^ Is the resistance greater than 5 ohms?

-> Yes GO to Pinpoint Test G295394t4.

-> No GO to Pinpoint Test G295394t5.

G295394t4: CHECK THE SIGNAL GROUND CIRCUIT TO THE EPB SWITCHPACK FOR HIGH RESISTANCE
1. Disconnect the battery negative terminal.
2. Disconnect the EPB control module electrical connector, CR32.
3. Measure the resistance between TL82, pin 06 (WU) and CR32, pin 12 (WU).

^ Is the resistance greater than 5 ohms?

-> Yes REPAIR the high resistance circuit. For additional information, refer to Vehicle/Diagrams. CLEAR the DTC. TEST the system for normal operation.

-> No GO to Pinpoint Test G295394t5.

G295394t5: CHECK THE VOLTAGE FROM THE EPB CONTROL MODULE TO THE SWITCHPACK
1. Reconnect the battery negative terminal.
2. Reconnect the EPB control module electrical connector, CR32.
3. Turn the ignition switch to the ON position.
4. Measure the voltage between TL82, pin 08 (WU) and GROUND.
5. Measure the voltage between TL82, pin 04 (RW) and GROUND.

^ Is either voltage less than 3 volts?

-> Yes GO to Pinpoint Test G295394t6.

-> No Check the EPB switch function. CLEAR the DTC. TEST the system for normal operation.

G295394t6: CHECK THE EPB CONTROL MODULE TO SWITCHPACK CIRCUITS FOR HIGH RESISTANCE
1. Disconnect the battery negative terminal.
2. Disconnect the EPB control module electrical connector, CR32.
3. Measure the resistance between TL82, pin 08 (WU) and CR32, pin 05 (WU).
4. Measure the resistance between TL82, pin 04 (RW) and CR32, pin 06 (RW).

^ Is either resistance greater than 5 ohms?

-> Yes REPAIR the high resistance circuit. For additional information, refer to Vehicle/Diagrams. CLEAR the DTC. TEST the system for normal operation.

-> No GO to Pinpoint Test G295394t7.

G295394t7: CHECK THE EPB CONTROL MODULE TO SWITCHPACK CIRCUITS FOR SHORT TO GROUND
1. Reconnect the battery negative terminal.
2. Measure the resistance between TL82, pin 08 (WU) and GROUND.
3. Measure the resistance between TL82, pin 04 (RW) and GROUND.

^ Is either resistance less than 10,000 ohms?

-> Yes REPAIR the short circuit. For additional information, refer to Vehicle/Diagrams. CLEAR the DTC. TEST the system for normal operation.

-> No Contact dealer technical support for advice on possible EPB control module failure.