Self-Diagnostic Mode

Self-Diagnostic Mode
To place the cluster in engineering test mode (ETM) carry out the following steps
1. Press and hold the stalk trip cycle button, for more than five seconds but less than eight seconds, whilst briefly pressing the vehicle START button. There is no initial display indication that the instrument cluster has entered ETM. If ETM has successfully been entered then 'ENGINEERING TEST MODE' will be displayed in the Message Centre when the stalk trip button is released.
2.To navigate forward through the instrument cluster Self-Diagnostic Mode tests, press the stalk trip cycle button.
3.Each push of the stalk trip cycle button will advance one step through the ETM sequence. It is not possible to move backward through the test sequence.
4.To exit the Self-Diagnostic Mode press and hold the stalk trip cycle button for more than three seconds.
5.The Self-Diagnostic Mode is also deactivated when the ignition switch is turned to the 'OFF' position or low battery voltage is detected.
6.If the Self-Diagnostic Mode cannot be accessed repeat the above paying particular care to the sequence timing.
7.The ETM text is not language configurable and will be displayed in English.

















1 If the cause is not visually evident, check for Diagnostic Trouble Codes (DTCs) and refer to the DTC Index.