Wheel Hub: Service and Repair

Front Wheel Bearing and Wheel Hub

Removal
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the body.
2 Remove the brake disc. For additional information, refer to Brake Disc - Vehicles With: Standard Brakes
3
NOTE:
LH illustration shown, RH is similar.
Release the wheel speed sensor.
- Release the clip.
- Tie aside.




4
CAUTION: Do not attempt to release the wheel hub by hitting it with a hammer directly, loosen the wheel hub retaining bolts partially before applying an even amount of force to the head of each bolts to release the wheel hub from the wheel knuckle. Failure to follow this instruction may cause damage to the component.
NOTE:
Note the fitted position.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
NOTE:
LH illustration shown, RH is similar.
Remove the hub assembly.
- Remove and discard the 4 bolts.

Installation
1
NOTE:
Align to the position noted on removal.
NOTE:
Make sure that all the component mating faces are clean.
Install the hub assembly.
- Clean the component mating faces.
- Tighten the bolts to 90 Nm (66 lb.ft).
2 Install the wheel speed sensor.
- Secure the clip.
3 Install the brake disc. For additional information, refer to Brake Disc - Vehicles With: Standard Brakes