Secondary Bulkhead Panel RH
Secondary Bulkhead Panel RH
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary
Removal
NOTE:
Removal steps in this procedure may contain installation details.
All vehicles
1 Disconnect the battery ground cable.
For additional information, refer to Battery Disconnect and Connect Battery Disconnect and Connect
For additional information, refer to Secondary Bulkhead Panel LH Secondary Bulkhead Panel LH
Vehicles with 3.0L diesel engine
Vehicles with 5.0L engine
All vehicles
Vehicles with 5.0L engine
Torque to: 12 Nm
All vehicles
Torque to: 40 Nm
Left-hand drive vehicles
For additional information, refer to Pedestrian Protection Hood Actuator RH Pedestrian Protection Hood Actuator RH
Torque to: 7 Nm
Torque to: 8 Nm
All vehicles
Torque to: 7 Nm
NOTE:
Do not disassemble further if the component is removed for access only.
Installation
CAUTION: Make sure that the clip is correctly located.
1 To install, reverse the removal procedure.