Front Disc Brake Pads with High Performance Brakes

Brake Pads
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary
Removal

CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.

NOTE:
Removal steps in this procedure may contain installation details.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1 Raise and support the vehicle.
For additional information, refer to Wheel and Tire Service and Repair









NOTE:
Left-hand shown, right-hand similar.









CAUTION: Removal of the clips is a delicate procedure, damage will occur if any force is used.

NOTE:
Left-hand shown, right-hand similar.
Lever the anti-rattle spring in the center of the spring until either side is released.





WARNING: If the brake caliper piston seal is damaged a new brake caliper must be installed.

CAUTION: Do not allow the brake caliper to hang on the brake hose.

NOTE:
Left-hand shown, right-hand similar.





NOTE:
Left-hand shown, right-hand similar.
Release the clip.





NOTE:
Left-hand shown, right-hand similar.





2 Repeat the above procedure on the opposite side.

Installation

WARNING: Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.

CAUTION: As the piston is pushed back into the caliper housing, the brake fluid level in the reservoir will rise. Do not allow the reservoir to overflow.
1 Press the piston into the caliper housing.








Apply grease C2C-39930 to the areas indicated.





NOTE:
Left-hand shown, right-hand similar.





NOTE:
Left-hand shown, right-hand similar.





NOTE:
Left-hand shown, right-hand similar.

Torque to: 58 Nm





NOTE:
Left-hand shown, right-hand similar.
Secure the bottom arm of the anti-rattle spring under the bottom anchor bracket of the caliper.
Compress the upper spring arm into the correct position, under the upper anchor bracket, whilst retaining the logo plate.
Using the screw-driver, tap the central locating tag into the locked position.









CAUTION: Make sure that the road wheels are in the straight ahead position.

CAUTION: Make sure that excessive force is not used. Failure to follow this instruction may result in damage to the vehicle.

CAUTION: Make sure that the brake hose is not twisted and is correctly located.
Pull downwards at the position shown.
2 Repeat the above procedure on the opposite side.
For additional information, refer to Wheel and Tire Service and Repair