Procedures

Roof Opening Panel Blind Rewind Procedure
For additional information, refer to Roof Opening Panel Blind Roof Opening Panel Blind




1 Remove the retaining clip.





CAUTION: Rotating the shaft clockwise will result in permanent damage to the tension spring.

CAUTION: Make sure that the tension is retained on the shaft until the clip is installed.

NOTE:
Make sure that any residual tension is released by gently pressing inwards on the shaft 2-3 times.
1 Using a suitable tool, rotate the shaft 10 full rotations counter clockwise.




2 Align the holes between the shaft and the blind.




3 Install the retaining clip.
For additional information, refer to Roof Opening Panel Blind Roof Opening Panel Blind