Glass Roof Panel Blind

Glass Roof Panel Blind
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary
Removal

NOTE:
Removal steps in this procedure may contain installation details.

NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
For additional information, refer to Battery Disconnect and Connect Battery Disconnect and Connect
For additional information, refer to Interior Rear View Mirror Interior Rear View Mirror
For additional information, refer to Overhead Console Overhead Console

NOTE:
The procedure must be carried out on both sides.
For additional information, refer to Sun Visor Service and Repair

NOTE:
The procedure must be carried out on both sides.
For additional information, refer to A-Pillar Trim Panel Pillar Trim

NOTE:
The procedure must be carried out on both sides.
For additional information, refer to B-Pillar Upper Trim Panel B-Pillar Upper Trim Panel

NOTE:
The procedure must be carried out on both sides.
For additional information, refer to C-Pillar Lower Trim Panel C-Pillar Lower Trim Panel

NOTE:
The procedure must be carried out on both sides.
For additional information, refer to Front Seat Removal and Replacement
For additional information, refer to Rear Seat Cushion Rear Seat Cushion [Vehicles Without: Split Rear Seat Backrest]

Torque to: 2 Nm

NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.

NOTE:
Make sure that the component is installed to the position noted on removal.

NOTE:
Right-hand shown, left-hand similar.

NOTE:
The procedure must be carried out on both sides.

Torque to: 2 Nm

WARNING: This step requires the aid of another technician.

WARNING: This step requires the aid of another technician.

CAUTION: Note the fitted position of the component prior to removal.

CAUTION: Make sure that these components are installed to the noted removal position.

NOTE:
This step requires the aid of another technician.

CAUTION: Note the fitted position of the component prior to removal.

NOTE:
Make sure that the component is installed to the position noted on removal.

NOTE:
Right-hand shown, left-hand similar.

CAUTION: Protect the surrounding trim to avoid damage.

NOTE:
Lower and reposition the headliner to aid access.

CAUTION: Make sure that the clip is correctly located.
1 Install the retaining clip.

CAUTION: Make sure that the clips are correctly located.

NOTE:
Follow the animation to make sure the roof opening panel blind is removed and installed correctly from and to the guides.

NOTE:
Support as necessary.
2 If the glass roof panel blind tension has been released, the glass roof panel blind rewind procedure must be followed.
For additional information, refer to Glass Roof Panel Blind Rewind Procedure

Installation
1 Make sure that the glass roof panel blind tension is correct prior to installation. If the tension has been released refer to the glass roof panel blind rewind procedure.
For additional information, refer to Glass Roof Panel Blind Rewind Procedure
2 To install, reverse the removal procedure.