Front Suspension

Front Stabilizer Bar
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary
Removal

CAUTION: The final tightening of the suspension components must be carried out with the vehicle on its wheels.

NOTE:
Removal steps in this procedure may contain installation details.

WARNING: Make sure to support the vehicle with axle stands.
1 Raise and support the vehicle.
For additional information, refer to Radiator Splash Shield Radiator Splash Shield
For additional information, refer to Air Deflector Service and Repair
For additional information, refer to Wheel and Tire Service and Repair





Torque to: 43 Nm





Torque to: 43 Nm













Torque to: 7 Nm





Torque to: 12 Nm





Torque to: 55 Nm





Torque to: 55 Nm













Torque to: 90 Nm





CAUTION: Make sure the wings and trim panels are covered and protected, failure to follow this instruction may result in damage to the vehicle.

Installation
1 To install, reverse the removal procedure.