4WD Models

1. Disconnect battery ground cable.
2. Raise and support vehicle.
3. Mark rear propeller shaft and yoke assembly for installation reference, then remove rear propeller shaft.
4. Remove inspection cover from converter housing, then mark converter driveplate and converter for assembly reference.
5. Remove bolts attaching converter to driveplate.
6. Position a suitable jack under transmission. Secure transmission onto jack using a safety chain.
7. Remove rear crossmember to transmission attaching bolts, then the rear crossmember.
8. Disconnect exhaust pipe from converter.
9. Disconnect and cap oil cooler lines.
10. Disconnect back-up light switch electrical connector and speedometer cable.
11. Disconnect transmission linkage, then remove transmission to engine attaching bolts.
12. Lower transmission from vehicle.
13. Reverse procedure to install.