Front Seat

SEAT - FRONT

WARNING: Before proceeding with the following repair procedure, review all warnings and cautions. Refer to Seats / Service Precautions.

REMOVAL




1. Remove the seat belt anchor bolt.
2. Slide seat back and remove the front bolts.
3. Slide seat to forward position and remove the rear bolt/nut.
4. Disconnect the electrical connectors and remove the seat.

INSTALLATION




1. Install the seats and connect the electrical connectors.
2. Slide the seat to the rearward position and install the bolts.
3. Tighten the outboard bolt to 43 N.m (32 ft.lbs.) and then tighten the inboard bolt to 43 N.m (32 ft.lbs.).
4. Slide the seat to the forward position and install the rear bolt and nut.
5. Tighten the fasteners to 43 N.m (32 ft.lbs.).
6. Install the seat belt anchor and bolt.
7. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed following service of any supplemental restraint system component. Refer to Computers and Control Systems / Testing and Inspection.
8. Following successful completion of the supplemental restraint system verification test procedure, perform the Occupant Classification System Verification Test using a DRBIII(R) scan tool. Refer to the appropriate diagnostic procedures.