Ignition Switch

IGNITION SWITCH REMOVAL
The ignition key must be in the key cylinder for cylinder removal. The key cylinder must be removed first before removing ignition switch.
1. Remove key cylinder. Refer to previous steps.





2. Remove lower steering column cover screws and remove cover.





3. Remove ignition switch mounting screw. Use tamper proof torx bit to remove the screw.





4. Using a small screwdriver, push on locking tab and remove switch from steering column.
5. Disconnect two electrical connectors at rear of ignition switch.

IGNITION SWITCH INSTALLATION
The ignition key must be in the key cylinder for cylinder removal. The key cylinder must be removed first before removing ignition switch.





1. Before installing ignition switch, rotate the slot in the switch to the ON position.
2. Connect two electrical connectors to rear of ignition switch. Make sure that locking tabs are fully seated into wiring connectors.
3. Position switch to column and install tamper proof screw. Tighten screw to 3 Nm (26 inch lbs.).
4. Install steering column lower cover.