Installation

LAMP - DOMESTIC




1. Position the rear lamp unit to the lamp opening of the quarter outer panel.

2. Reconnect the two wire harness connectors to the two bulb sockets on the back of the lamp housing.

3. Engage the retainer on the wire harness for the lamp into the tab on the back of the lamp housing.

4. Check to be certain that the two grommets (5) are in good condition and properly installed in the quarter outer panel (1).

5. Align the two ball studs (4) on the outboard side of the lamp housing (3) with the two grommets in the quarter outer panel.

6. Using hand pressure, push firmly and evenly on the outboard side of the lamp until both ball studs snap into the grommets.

7. Install the two plastic push-pin fasteners (2) that secure the rear lamp unit to the side jamb of the liftgate opening.

8. Reconnect the battery negative cable.