Removal

LAMP - DOMESTIC




1. Disconnect and isolate the battery negative cable.

2. Open the liftgate to access and remove the two plastic push-pin fasteners (2) that secure the rear lamp unit (3) to the side jamb of the liftgate opening.

3. Pull the outboard side of the rear lamp unit rearward far enough to unsnap the two ball studs (4) on the outboard side of the lamp housing from the two round grommets (5) in the quarter outer panel (1).

4. Pull the lamp away from the vehicle far enough to access and disengage the retainer on the wire harness for the lamp from the tab on the back of the lamp housing.

5. Disconnect the two wire harness connectors from the two bulb sockets on the back of the lamp housing.

6. Remove the lamp from the lamp opening of the quarter outer panel.