Engine - Removal

ENGINE





1. Remove hood.
2. Remove engine cover (1).





3. Perform fuel pressure release procedure Service and Repair.
4. Remove retainers (5) and remove air inlet (2).
5. Remove air cleaner housing assembly (1) and clean air hose Air Cleaner Body - Removal.





6. Disconnect both cables from battery (3).
7. Remove battery (3).





8. Remove battery tray (1).
9. Drain cooling system Service and Repair.





10. Remove coolant reservoir (3).
11. Remove power steering reservoir (2).
12. Remove windshield washer reservoir (1).





13. Remove coolant hoses from coolant adapter (3).





14. Remove grill closure panel.
15. Remove upper radiator hose support (1).





16. Disconnect engine electrical connectors and reposition harness.
17. Remove air intake tube from throttle body.
18. Disconnect fuel line (3) from fuel rail.





19. Remove vacuum lines from throttle body and intake manifold.
20. Remove harness from intake (2).
21. Remove throttle body support bracket (1).





22. Disconnect electronic throttle control and manifold flow control valve electrical connectors.
23. Remove PCV hose (5), and make-up air hose (2) from valve cover.
24. Remove dipstick.





25. Remove intake bolts (1-5) and remove intake.
26. Disconnect electrical connectors and reposition harness.
27. Remove accessory drive belt.





28. Remove power steering line support at engine mount (1) and exhaust manifold.
29. Remove power steering pump and set aside.
30. Remove upper idler pulley.





31. Remove ground strap near right tower.
32. Raise vehicle.
33. Remove right front tire.
34. Remove splash shield.





35. Drain oil (2).





36. Remove inspection cover (1) and mark torque converter to flywheel.





37. Remove torque converter bolts (1).
38. Remove lower bellhousing bolts (2).





39. Remove A/C compressor (1) mounting bolts.
40. Remove generator and lower idler pulley.





41. Disconnect crankshaft position sensor electrical connector and remove crankshaft position sensor (2).





42. Remove exhaust variable valve timing solenoid.
43. Install engine lift chain (1) as shown to cylinder head.
44. Connect the chain to the rear engine lift hook.

45. Install engine lifting crane.





46. Remove right engine mount through bolt (4).
47. Remove engine mount adapter retaining bolts (3) and mount adapter (2).
48. Lift engine from engine compartment.