P2166

P2166-ACCELERATOR PEDAL POSITION SENSOR 1 MAXIMUM STOP PERFORMANCE

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Ignition on. During in plant mode the APP Sensors need to be checked to make sure that idle and full pedal travel can be reached on both sensors.

- Set Condition:
APPS No.1 has failed to achieve the required maximum value during In Plant testing. One trip fault and the code will set within five seconds. Engine will only idle. ETC light will illuminate.





Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Pre-Diagnostic Troubleshooting Procedure.

1. IN PLANT TEST FAILURE
1. Ignition on, engine not running.

NOTE: This DTC is set when the APP Sensors are learned in plant but do not reach the Minimum or Maximum voltage range.

2. With a scan tool, select View DTCs.
3. With the scan tool, erase DTCs.
4. Start the engine.
5. With the scan tool, view DTCs.

Is the DTC Active at this time?

Yes

- Go To 2

No

- Perform the INTERMITTENT CONDITION diagnostic procedure. Intermittent Condition Test.

2. APPS RELEARN
1. With a scan tool select the ETC RELEARN function.
2. Next, erase DTCs.
3. Start the engine.

Does the DTC return?

Yes

- Replace the APPS Assembly. After installation is complete, use a scan tool and select the ETC RELEARN function.
- Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test.

No

- Test Complete.