U1415

U1415-IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION DATA

For a complete wiring diagram Refer to the Wiring Information.

- When Monitored:
With the ignition on. The Occupant Restraint Controller (ORC) on board diagnostics continuously monitors the CAN Bus message from the TIPM containing the ORC configuration data.

- Set Condition:
This DTC will set if the data is invalid or missing.





1. VERIFY TOTALLY INTEGRATED POWER MODULE (TIPM) OPERATION
1. Turn the ignition on.
2. With the scan tool, read TIPM DTCs.

Does the scan tool display any TIPM DTCs?

Yes

- Select appropriate symptom. Repair all TIPM active DTCs or reprogram the TIPM before diagnosing the ORC DTCs.

No

- Go To 2

2. CHECK OPERATION OF THE OCCUPANT RESTRAINT CONTROLLER

WARNING: Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

WARNING: If the airbag control module is dropped at any time, it must be replaced. Failure to take the proper precautions could result in accidental airbag deployment and serious or fatal injury.

1. Replace the Occupant Restraint Controller.

WARNING: Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

2. Use the most current software available. Connect the scan tool to the Data Link connector.
3. Wait one minute, and read active codes and if there are none present read the stored codes.

Did the active U1415-IMPLAUSIBLE/MISSING VEHICLE CONFIGURATION DATA DTC return?

Yes

- Replace the Totally Integrated Power Module (TIPM).

- Perform the BODY VERIFICATION TEST.Body Verification Test.

No

- Repair is complete.
- Perform the AIRBAG SYSTEM VERIFICATION TEST.Airbag System Verification Test.