Operation CHARM: Car repair manuals for everyone.

Heated Glass - Operation






OPERATION






NOTE: MTC A/C-heater control shown. ATC A/C-heater control similar.

The electric backlight (EBL) system is controlled by a momentary push-button switch inside of the mode control knob (4) on the A/C-heater control (1), located in the instrument panel center bezel. When the rear window defogger switch is pressed to ON with the ignition switch in RUN, the switch sends a request signal to the Cabin Compartment Node (CCN), which sends a message on the CAN-B Bus to the Totally Integrated Power Module (TIPM) to energize the internal EBL high side driver. When energized, the EBL high side driver provides battery current to the rear window defogger grid lines and the heated side view mirrors (when equipped). The grid lines heat the glass to help clear the rear window and side mirror surfaces of fog or frost.

An amber indicator in the rear window defogger switch will illuminate when the EBL system is turned on.

NOTE: The EBL system turns off automatically after 10 minutes of initial operation. Each following activation cycle of the EBL system will last 5 minutes.

The EBL system will automatically turn off after an initial programmed time interval of about 10 minutes as long as the ignition switch is in RUN. After the initial time interval has expired, if the rear window defogger switch is pressed to ON again during the same ignition cycle, the EBL system will automatically turn off after about 5 minutes. The EBL system will also turn off if the ignition switch is turned to any position other than RUN or by manually pressing the rear window defogger switch a second time.

Repair of the rear window defogger grid lines, bus bars, terminals or pigtail wires can be accomplished using the Mopar(R) Rear Window Defogger Repair Kit (Part Number 04549275) or equivalent Service and Repair.

The EBL control system is diagnosed using a scan tool.