Cruise Control Switch: Service and Repair

1. Remove horn button insert, steering wheel, anti-theft cover, locking plate and horn contact.
2. Disconnect turn signal lever from steering column and allow to hang loose outside steering column.
3. Remove flasher knob, hold-down screws and turn signal switch.
4. Remove lower steering column cover, if equipped.
5. Disconnect four-wire connector. On tilt column, remove harness from plastic connector and tape two wires back along harness. Tie a string to harness. On standard column tape string to plastic connector.
6. Remove lever and harness assembly from column.
7. Reverse procedure to install. On tilt column, route harness through opening in left side of steering shaft.