Engine Control Module: Service and Repair

NOTE:
The engine controller is located in the engine compartment next to the air cleaner.

Diagnostic Connector Location:

REMOVAL

1. Disconnect battery negative cable.

Engine Controller:

2. Loosen 60-way connector mounting screw until connector can be disengaged from engine controller.

3. Pull 60-way connector straight back from engine controller.

4. Remove engine controller mounting screws.

5. Remove engine controller.


INSTALLATION

1. Install engine controller. Torque mounting screws to 1 Nm (9 in. lbs.).

2. Engage 60-way connector into engine controller. Torque connector mounting screw to 4 Nm (35 in. lbs.).

3. Connect negative cable to battery.