Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 1994 >> Cherokee 2WD L4-150 2.5L VIN P MFI >> Repair and Diagnosis >> Powertrain Management >> Ignition System >> Crankshaft Position Sensor >> Service and Repair >> With Automatic Transmission
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

With Automatic Transmission

Crankshaft Position Sensor (Typical):




REMOVAL
1. Disconnect negative battery cable.
2. Disconnect sensor electrical connector, located near rear of intake manifold.
3. Remove nut holding sensor wiring clip to fuel rail.
4. Remove sensor mounting bolt(s) or nuts.
5. Remove the sensor from vehicle.
6. Remove clip from sensor wiring harness.


INSTALLATION
1. Be sure the paper spacer is installed on bottom of new sensor.

NOTE: If original sensor is being reinstalled, clean bottom of sensor before installation. Obtain a new paper spacer and install on sensor. If spacer is not installed, sensor will be damaged when engine is started.

2. Position camshaft position sensor in transmission housing and install mounting bolt finger tight.
3. Gently push down on sensor until paper spacer contacts the outer edge of flywheel.
4. Torque sensor mounting bolt to 6-to-8 Nm (50-to-70 in. lbs.).
5. Connect the electrical connector to the sensor.
6. Install clip on sensor wire.
7. Install clip over fuel rail stud and tighten mounting nut.
pro multis · About Operation CHARM