Operation CHARM: Car repair manuals for everyone.
Home >> Jeep >> 1997 >> Cherokee 4WD L4-150 2.5L VIN P MFI >> Repair and Diagnosis >> Cruise Control >> Cruise Control Servo >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Cruise Control Servo: Service and Repair

REMOVAL
1. Disconnect negative battery cable at battery.
2. Disconnect vacuum hose at servo.
3. Disconnect electrical connector at servo.
4. Block throttle to full open position.
5. Remove 2 servo mounting nuts holding cable and cable sleeve to mounting bracket.

Servo Cable Clip Remove/Install - Typical:




6. Pull servo away from mounting bracket to expose cable retaining clip and remove clip.
7. Pull servo away from cable and remove from vehicle.

INSTALLATION
1. Position servo near end of servo cable.
2. Block throttle to full open position. Align hole in cable sleeve with hole in servo pin and install cable retaining clip.
3. Insert servo studs through holes in servo mounting bracket.
4. Install servo mounting nuts. Tighten to 8.5 Nm (75 in lb) torque.
5. Connect vacuum hose at servo.
6. Connect electrical connector at servo.
7. Remove throttle block.
8. Connect negative battery cable to battery.
pro multis · About Operation CHARM