Cruise Control Servo: Service and Repair

REMOVAL
1. Disconnect negative battery cable at battery.
2. Disconnect vacuum hose at servo.
3. Disconnect electrical connector at servo.
4. Block throttle to full open position.
5. Remove 2 servo mounting nuts holding cable and cable sleeve to mounting bracket.

Servo Cable Clip Remove/Install - Typical:

6. Pull servo away from mounting bracket to expose cable retaining clip and remove clip.
7. Pull servo away from cable and remove from vehicle.

INSTALLATION
1. Position servo near end of servo cable.
2. Block throttle to full open position. Align hole in cable sleeve with hole in servo pin and install cable retaining clip.
3. Insert servo studs through holes in servo mounting bracket.
4. Install servo mounting nuts. Tighten to 8.5 Nm (75 in lb) torque.
5. Connect vacuum hose at servo.
6. Connect electrical connector at servo.
7. Remove throttle block.
8. Connect negative battery cable to battery.