Programming Cold Overdrive Feature (All Applications)

Using the DRB III, use the following procedures to program the overdrive cutoff feature.

1. Connect the DRB III (Scan Tool) to the vehicle and power it up.

2. Use the arrow keys and select # 1 DRB III STANDALONE on the DRB III MAIN MENU Screen.

3. Use the arrow keys and select # 1 1994 - 1998 DIAGNOSTICS on the DRB III STAND-ALONE MAIN MENU.

4. Use the arrow keys and select # 1 ENGINE on the DRB III SELECT SYSTEM MENU.

5. The module ID screen will appear, press enter to move to next menu.

6. From the SELECT FUNCTION MENU, press the right arrow key for the next page and select # 1 MISCELLANEOUS.

7. From the SELECT MISCELLANEOUS FUNCTION MENU, press the right arrow key for the next page and select # 1 COLD OVERDRIVE FEATURE.

8. Follow the steps presented on the DRB III which will prompt you through the feature selection.

9. When the password is asked for use: 84362172.

10. Follow the remaining prompts for overdrive feature verification.

NOTE:
IT IS IMPERATIVE THAT THE TRANSMISSION COOLER BYPASS KIT BE INSTALLED PRIOR TO DISABLING THE INHIBITOR FEATURE. TRANSMISSION DAMAGE MAY OCCUR IF THE BYPASS KIT IS NOT INSTALLED.