Cruise Control Servo: Service and Repair

REMOVAL
1. Disconnect negative battery cable at battery.

Speed Control Servo Location:

2. Disconnect vacuum line at servo.
3. Disconnect electrical connector at servo.
4. Disconnect servo cable at throttle body. Refer to Servo Cable Removal/installation.
5. Remove 2 mounting nuts holding servo cable sleeve to bracket.

Servo Cable Clip Remove/Install - Typical:

6. Pull speed control cable sleeve arid servo away from servo mounting bracket to expose cable retaining clip and remove clip.

NOTE: The servo mounting bracket displayed in is a typical bracket and may/may not be applicable to this model vehicle.

7. Remove servo from mounting bracket.

INSTALLATION
1. Position servo to mounting bracket.
2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining dip.
3. Insert servo mounting studs through holes in servo mounting bracket.
4. Install servo mounting nuts and tighten to 8.5 N.m (75 in lbs).
5. Connect vacuum line at servo.
6. Connect electrical connector at servo.
7. Connect servo cable to throttle body. Refer to Servo Cable Removal/Installation.
8. Connect negative battery cable to battery.
9. Before starting engine, operate accelerator pedal to check for any binding.