Power Seat Motor: Service and Repair

REMOVAL
1. Move the seat to its fully raised and fully forward position, if possible.
2. Disconnect and isolate the battery negative cable.

Driver Seat Belt Switch Connector:

3. Unplug the seat belt switch wire harness connector from the driver side seat belt buckle half on the inboard side of the seat.

Power Seat Remove/Install:

4. Remove the two screws that secure the front of the seat adjuster frame to the floor pan seat mounting reinforcement.
5. Remove the screw that secures the outboard rear of the seat adjuster frame to the floor pan.
6. Remove the nut that secures the inboard rear of the seat adjuster frame to the stud on the floor pan.
7. Unplug the power seat wire harness connector from the body wire harness connector.
8. Remove the driver side power seat and adjuster assembly from the vehicle.
9. Unplug the power seat wire harness connectors at each of the three power seat motors.

Power Seat Adjuster And Motors Remove/Install:

10. Remove the four nuts that secure the seat adjuster and motors assembly to the seat cushion frame and remove the adjuster and motors assembly from the seat.
11. Reverse the removal procedures to install. Tighten the seat mounting hardware as follows:
- Seat adjuster to seat cushion frame nuts - 25 N.m (18 ft. lbs.)
- Seat adjuster to floor panel screws - 27 N.m (20 ft. lbs.)
- Seat adjuster to floor panel nut - 40 N.m (30 ft. lbs.).