Cruise Control Servo Cable: Service and Repair

REMOVAL
1. Disconnect negative battery cable at battery.

Servo Cable To Bellcrank-Removal/Install:

2. Using finger pressure only, remove cable connector by pushing connector off the throttle body bellcrank pin. DO NOT try to pull cable connector off perpendicular to the bellcrank pin. Connector will be broken.

Squeeze Tabs At Cable Locking Plate:

3. Two squeeze tabs are located on sides of speed control cable at cable locking plate. Squeeze the tabs together and push cable out of cable locking plate.
4. Unclip cable from cable guide at valve cover.
5. Disconnect servo cable at servo. Refer to Speed Control Servo-Removal/Installation.

INSTALLATION
1. Attach end of cable to speed control servo. Refer to Speed Control Servo Removal/Installation.
2. Install cable into cable locking plate (snaps in).
3. Install cable connector at throttle body bellcrank pin (snaps on).
4. Clip cable to cable guide at valve cover.
5. Connect negative battery cable to battery
6. Before starting engine, operate accelerator pedal to check for any binding.