Seals and Gaskets: Service and Repair

REMOVAL
1. Raise and support vehicle.
2. Remove propeller shaft.

Remove Extension Housing Seal:

3. Using a suitable seal puller or screw with a slide hammer, remove the extension housing seal.

INSTALLATION
1. Clean seal bore of extension housing of any residual sealer material from original seal.

Install Extension Housing Seal:

2. Using Tool Handle C-4171 and Seal Installer 8212, install new extension housing seal so that the seal is located 0 - 0.5 mm (0 - 0.02 inch) to the face of the extension housing.
3. Install propeller shaft.
4. Check and add fluid to transmission as necessary.
5. Lower vehicle.