Adapter Housing Seal

REMOVAL
1. Hoist and support vehicle.
2. Remove transfer case.

Remove Adapter Housing Seal:

3. Using a suitable pry tool, or a slide hammer mounted screw, remove the adapter housing seal.

INSTALLATION
1. Clean seal bore of adapter housing of any residual sealer material from original seal.

Install Adapter Housing Seal:

2. Using Tool Handle C-4171 and Seal Installer 8208, install new seal so that the seal is located 0 ± 0.2 mm (0 ± 0.008 inch) to the seal bore face of adapter housing.
3. Install transfer case.
4. Check and add fluid to transmission as necessary.
5. Lower vehicle.