Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay), please get in contact with us ASAP (truly, it is urgent): email operation-charm [[at]] tuta.io or click to submit anonymously

Front Mount

The front mounts support the engine at each side. These supports are made of resilient rubber.

REMOVAL
1. Disconnect negative cable from battery.
2. Raise the vehicle.
3. Support the engine.

Fig.25 Front Mounts:

4. Remove the nut from the through bolt. DO NOT remove the through bolt.
5. Remove the retaining bolts and nuts from the support cushions.
6. Remove the through bolt.
7. Remove the support cushions.

INSTALLATION
1. If the engine support bracket was removed, position the bracket onto the block and install the attaching bolts. Tighten the engine support bracket bolts to 61 Nm (45 ft. lbs.) torque.

Fig.26 Support Cushion Bracket:

2. If the support cushion bracket was removed, position the bracket onto the lower front sill. Install support cushion bracket bolts and nuts. Tighten the bolts to 54 Nm (40 ft. lbs.) torque. Tighten the nuts to 41 Nm (30 ft. lbs.) torque.
3. Place the support cushion into position on the support cushion bracket. Install and tighten the bolts and nuts to 41 Nm (30 ft. lbs.) torque.
4. Install the through bolt and the retaining nut. Tighten the through bolt nut to 65 Nm (48 ft. lbs.) torque.
5. Remove the engine support.
6. Lower the vehicle.
7. Connect negative cable to battery.