Power Window Switch: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the bezel near the inside door latch release handle by inserting a straight-bladed screwdriver in the notched end of the bezel and prying gently upwards.

Rear Door Trim Panel Remove/Install:

3. Remove the screw located beneath the bezel that secures the rear door trim panel to the inner door panel.
4. Remove the trim cap and screw near the rear of the rear door armrest.
5. Using a trim stick or another suitable wide flat-bladed tool, gently pry the rear door trim panel away from the door around the perimeter to release the trim panel retainers.

NOTE: To aid in the removal of the trim panel, start at the bottom of the panel.

6. Pull the rear door trim panel away from the inner door panel far enough to access and unplug the wire harness connector from the power window switch.

Rear Door Power Window Switch Remove/Install:

7. Unsnap the power window switch from the receptacle on the back side of the rear door trim panel.
8. Reverse the removal procedures to install. Tighten the trim panel mounting screws to 1.3 N.m (12 in. lbs.).