Power Window Control Module: Service and Repair

Before replacing the door module, use a DRB scan tool to determine the current settings for the door module programmable features. These settings should be duplicated in the replacement door module using the DRB scan tool, before returning the vehicle to service.
1. Disconnect and isolate the battery negative cable.
2. Remove the bezel near the inside door latch release handle by inserting a straight-bladed screw driver in the notched end of the bezel and prying gently upwards.

Front Door Trim Panel Remove/Install:

3. Remove the screw located beneath the bezel that secures the front door trim panel to the inner door panel.
4. Remove the trim cap and screw near the rear of the front door armrest.
5. Remove the trim cap and screw at the upper front corner of the front door trim panel.
6. Remove the screw located above the front door speaker grille on the front door trim panel.
7. Using a trim stick or another suitable wide flat-bladed tool, gently pry the front door trim panel away from the door around the perimeter to release the trim panel retainers.

NOTE: To aid in the removal of the trim panel, start at the bottom of the panel.

8. Pull the front door trim panel away from the inner door panel far enough to access and unplug the wire harness connectors from the door module and, if the vehicle is so equipped, from the front door courtesy lamp.

Door Module Remove/Install:

9. Remove the five screws that secure the door module to the back of the front door trim panel.
10. Remove the door module from the trim panel.
11. Reverse the removal procedures to install. Tighten the mounting screws to 2.2 N.m (20 in. lbs.).

NOTE: If a new door module is installed, the programmable features must be enabled and/or disabled to the customer's preferred settings. Use a DRB scan tool and the proper Diagnostic Procedures to perform these operations.