Instrument Cluster / Carrier

Tighten the three screws that secure the accessory switch bezel to the instrument panel to 9.2 N.m (20 in. lbs.).

Tighten the four screws that secure the cluster bezel to the instrument panel beneath the instrument panel center bezel to 2.2 N.m (20 in. lbs.).

Tighten the four screws that secure the instrument cluster to the instrument panel to 2.2 N.m (20 in. lbs.).

Tighten the five screws that secure the end cap to the instrument panel to 2.2 N.m (20 in. lbs.).

Tighten the six screws that secure the end cap to the instrument panel to 2.2 N.m (20 in. lbs.).

Tighten the two nuts that secure the instrument panel center support bracket to the studs on the floor panel transmission tunnel to 28 N.m (250 in. lbs.).

Tighten the two nuts that secure the center support bracket to the studs on the instrument panel to 28 N.m (250 in. lbs.).

Tighten the four screws and two nuts that secure the top of the instrument panel to the top of the dash panel near the base of the windshield to 7 N.m (60 in. lbs.).

Tighten the right and left instrument panel cowl side roll down screws to 28 N.m (250 in. lbs.).

Tighten instrument panel-to-floor wire harness connector Screw near the floor panel transmission tunnel under the instrument panel to 4 N.m (35 in. lbs.).