Alarm Module: Service and Repair

WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, REFER TO AIRBAGS SYSTEMS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

SENTRY KEY IMMOBILIZER MODULE REPLACEMENT

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the steering column opening cover from the instrument panel. Refer to Steering and Suspension/Steering/Steering Column Opening Cover
3. Disconnect the instrument panel wire harness connector from the Sentry Key Immobilizer Module SKIM. connector receptacle.




4. Remove the one screw that secures the SKIM to the bottom of the steering column housing between the ignition switch and the ignition lock cylinder.
5. Pull the lower right side of the fixed column shroud away from the ignition lock cylinder far enough to disengage the antenna ring of the SKIM from around the ignition lock cylinder housing.
6. Remove the SKIM from the steering column.

INSTALLATION
1. Position the SKIM under the steering column.
2. Pull the lower right side of the fixed column shroud away from the ignition lock cylinder far enough to engage the antenna ring of the SKIM around the ignition lock cylinder housing.
3. Install and tighten the one screw that secures the SKIM to the bottom of the steering column housing between the ignition switch and the ignition lock cylinder. Tighten the screw to 3.4 Nm 30 in lbs.
4. Reconnect the instrument panel wire harness connector to the SKIM connector receptacle.
5 Install the steering column opening cover onto the instrument panel. Refer to Steering and Suspension/Steering/Steering Column Opening Cover in the Replacement for the procedures.
6. Reconnect the battery negative cable.