Memory Seat Glide

Memory Seat Glide (If Equipped)
The intent of this feature is to allow for easier entry and exit to the vehicle by moving the seat rearward a short distance when the operator turns the vehicle OFF. The seat can be recalled to one of it's two set memory positions by pressing either of the memory recall buttons on the switch or the RKE transmitters. If any seat movement is initiated whether manual or by memory recall after the ignition has been turned OFF this will cancel any ensuing glide to enter movement until the next ignition cycle.

This feature can be enabled/disabled by the owner through the electronic vehicle information center (EVIC) or using the DRB III. When using the DRB III it will also inform as to what state it is in. To reinstate the feature simply repeat the process.

Guard Bands
The module provides guard bands which prevent the seat track from hitting the hard limits of the given seat axis during manual power seat operation. The guard band values for each hard limit are stored in EEPROM. The guard band can be bypassed by running the seat to the end of its travel and then releasing the switch and pressing it again. The seat will move a short distance further. Once the seat is past the guard band it can be stored in memory but if recall is initiated the seat will move to the guard bands and no further.

When a seat module or seat track assembly is replaced the DRB III must be used to perform the "Reset Guard Bands" procedure. WARNING: The operator must be out of the seat when this procedure is being used as the seat will move to the end of it's travel in all 8 positions.