Power Door Lock Control Module: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the trim panel from the inside of the front door.
3. Disconnect the door wire harness connectors from the door module connector receptacles.

Fig.8 Door Module Remove/Install:

4. Remove the three screws that secure the door module to the front door trim panel.
5. Remove the door module from the front door trim panel.

INSTALLATION
1. Position the door module onto the front door trim panel.
2. Install and tighten the three screws that secure the door module to the front door trim panel. Tighten the screws to 2.2 Nm (20 in.lbs.).
3. Reconnect the door wire harness connectors to the door module connector receptacles.
4. Reinstall the trim panel onto the front door inner panel.
5. Reconnect the battery negative cable.