Overhead Console Assembly

DISASSEMBLY
US/M/Step Push Button Module Disassembly
1. Remove the overhead console from the vehicle.
2. Unplug the push button module wire harness connector from the trip computer, compass, and thermometer display module.

Fig.5 Push Button Module Remove/Install:

3. Remove the four screws that secure the push button module to the overhead console housing.
4. Remove the push button module from the overhead console.
5. Tighten the mounting screws to 2.2 Nm (20 in.lbs.).

Garage Door Opener Storage Bin Disassembly
1. Open the garage door opener storage bin door.
2. Using a trim stick or another suitable wide flat-bladed tool, gently pry between the door pivot pin and the pivot hole on one side of the overhead console housing until the pivot pin clears the pivot hole.
3. Use a gentle twisting action to remove the garage door opener storage bin door from the overhead console housing.
4. To install, insert the pivot pin on one side of the door into the pivot hole in the overhead console housing. Gently depress the pivot pin on the other side of the door until it clears the side of the garage door opener storage bin opening of the overhead console housing, and push the door into the opening. Guide the door into the opening so that the second pivot pin snaps into its pivot hole.

Sunglass Storage Bin Disassembly
The sunglasses storage bin door and bin, housing, damper, spring and latch are serviced only as a unit. Remove the sunglasses storage bin module from the overhead console as follows:
1. Disengage the overhead console courtesy lamp wire harness from the retainers molded into the sun-glasses storage bin housing.

Fig.6 Sunglasses Storage Bin Module Remove/Install:

2. Remove the six screws that secure the sunglasses storage bin module to the overhead console housing.
3. Remove the sunglasses storage bin module from the overhead console.
4. Tighten the mounting screws to 2.2 Nm (20 in.lbs.).

ASSEMBLY
US/M/Step Push Button Module Assembly
1. Position the push button module and install the retaining screws. Torque the screws to 2.2 Nm (20 in.lbs.).
2. Connect the push button module to the trip computer, compass and thermometer display module.

Garage Door Opener Storage Bin Assembly
1. The install, insert the pivot pin on one side of the door into the pivot hole in the overhead console housing. Gently depress the pivot pin on the other side of the door until it clears the side of the garage door opener storage bin opening of the overhead console housing, and push the door into the opening. Guide the door into the opening so that the second pivot pin snaps into its pivot hole.

Sunglass Storage Bin Assembly
1. Position the sunglass storage bin and install the retaining screws. Torque the screws to 2.2 Nm (20 in.lbs.).
2. Engage the overhead console courtesy lamp wire harness on the retainers molded into the sunglass storage bin housing.