Glove Box Lock Cylinder

GLOVE BOX LOCK CYLINDER

REMOVAL
1. Insert the key into the glove box lock cylinder and turn the lock cylinder to the unlocked position.
2. Unlatch and open the glove box.

Glove Box Lock Cylinder Remove/Install:

3. With the key still in the lock cylinder, insert a small pin punch or a stiff wire into the lock cylinder release hole and depress the lock cylinder retaining tumbler.
4. While holding the retaining tumbler depressed, rotate the key in the lock cylinder clockwise and press outward on the back of the lock cylinder from the inside of the glove box door until the lock cylinder comes out of the glove box latch lock cylinder bore.

INSTALLATION
1. Insert the key into the glove box lock cylinder and align the lock cylinder tumblers with the ramp in the glove box latch lock cylinder bore. The ramp is located at about the 7 o'clock position.
2. Push the glove box lock cylinder firmly into the lock cylinder bore while rotating the key and cylinder counterclockwise to the 6 o'clock position, where the lock cylinder retaining tumbler will snap back into place.
3. Close and latch the glove box.