Extension Housing: Service and Repair

REMOVAL
YOKE BUSHING
1. Raise and support vehicle.
2. Mark reference lines on the propeller shaft and remove shaft.
3. Remove housing yoke seal.





4. Insert Remover 6957 into rear housing and tighten tool to bushing and remove bushing (Fig. 130).

INSTALLATION
YOKE BUSHING
1. Align bushing oil hole with oil slot in rear housing.
2. Tap bushing into place with Installer 6951 and Handle C-4171.





3. Install new oil seal in housing using Installer C-3972-A (Fig. 131).
4. Install propeller shaft with reference marks aligned.
5. Remove support and lower vehicle.
6. Check transmission fluid level.