Wiper and Washer Systems: Locations

The Body Control Module (BCM) is located on the Junction Block (JB) underneath the driver side end of the instrument panel.

The dual fluidic front washer nozzles are secured with integral snap features to dedicated openings in the cowl plenum cover/ grille panel located near the base of the windshield.

The front washer pump/motor unit is located in a dedicated hole on the lower outboard side of the washer reservoir, behind the inner fender liner ahead of the left front wheel.

The front washer pump is located ahead of and below the rear washer pump.

The wiper arms are secured to the two wiper pivots, which extend through the cowl plenum cover/grille panel located near the base of the windshield.

The washer fluid level switch is located in a dedicated hole near the center of the forward surface of the washer reservoir, behind the inner fender liner ahead of the left front wheel.

The wiper high-low relay is located in the Power Distribution Center (PDC) in the engine compartment near the battery.

The wiper ON-OFF relay is located in the Power Distribution Center (PDC) in the engine compartment near the battery.

The front check valve is integral to the front washer nozzle plumbing wye fitting located in the cowl plenum beneath the cowl plenum cover/grille panel near the base of the windshield.

The two front washer nozzles have integral snap features that secure them in dedicated holes in the cowl plenum cover/grille panel located near the base of the windshield.

The front washer pump/motor unit is located on the outboard side and near the front of the washer reservoir, between the left front inner and outer fender panels.

The front wiper arms are the rigid members located between the wiper pivots that protrude from the cowl plenum cover/grille panel near the base of the windshield and the wiper blades on the windshield glass.

The front and rear washer/pump motor units are located in a sump area near the front of the reservoir to be certain that washer fluid will be available to the pumps as the fluid level in the reservoir becomes depleted.

The wiper high/low relay is located in the Power Distribution Center (PDC) near the battery in the engine compartment.

The wiper ON/OFF relay is located in the Power Distribution Center (PDC) near the battery in the engine compartment

The rear washer pump/motor unit is located in a dedicated hole on the lower outboard side of the washer reservoir, ahead of the left front wheel housing.

The rear washer pump mounting hole is located higher on the reservoir than the front washer pump mounting hole.

The right multi- function switch located on the right side of the steering column, just below the steering wheel.

The rear washer pump/motor unit is located on the outboard side and near the rear of the washer reservoir, between the left front inner and outer fender panels.

The rear wiper arm is the rigid member located between the rear wiper motor output shaft that protrudes from the outer liftgate panel near the base of the liftgate glass opening and the rear wiper blade.